• Letters & Number Poly-carbonate Chocolate Mold 600Letters & Number Poly-carbonate Chocolate Mold 600
  •  CA$26.95 

    In Stock

Poly-carbonate letters & number chocolate mold

Size of letter/number: 30mm

Mold dimensions: 275mm x 175mm

Polycarbonate Instructions

Use molds at room temperature.

Fill, clean, dry mold with properly-prepared chocolate.

Tap molds on counter top or work surface several times to remove air bubbles

Using a bench scraper or offset spatula, scrape excess chocolate from the top of the molds. Excess chocolate inhibits release from the mold.

Place on level surface in the refrigerator until set.

Once set, remove from the refrigerator (usually 20 mins or less).

Unmold the pieces from the mold by turning the mold upside down and give it a good strong tap on the countertop or work surface. Repeat until all cavities have been emptied.

If you find that your finished pieces are sticking, you can polish the cavities with an eye glass cleaning cloth or a cotton make up pad to buff/polish the mold. This will aid in the release of the finished product.

Do not try to pry the pieces from the cavity, they will only release when properly set. Most objects will damage the finished pieces and likely the mold itself.

Tip: When using a mold for the first time, they tend to be a little more difficult to remove as the mold has not been “seasoned”. If possible, run a few “test” batches to start the seasoning process. The more they are used, the easier they release!

Disclaimer: Actual product packaging and ingredients may contain more and different information than what is shown on our website. We recommend that you do not rely solely on the information presented and that you always read the label, warnings, and directions before using or consuming a product.
  • 8029859109315 UPC/EAN:
Share This Product

Do you want to add this item to your wishlist?